How To Jailbreak OFFICIAL iOS 5 & Preserve Baseband iPhone 4/3Gs iPod Touch 4G/3G & iPad

Sn0wbreeze Jailbreak iOS 5

This post will show you how to jailbreak iOS 5 and preserve your baseband on iPhone 4/3Gs iPod Touch 4G/3G & iPad using Sn0wbreeze – v2.8b8

************ Disclaimer **************
You are doing this at your own risk and I am not responsible for anything that happens to your iDevice.

Devices Supported:
iPhone 4 [GSM]
iPhone 4 [CDMA]
iPhone 3GS
iPod Touch 3G
iPod Touch 4
iPad 1G

Things You’ll Need:
Sn0wbreeze – v2.8b8 (Download)
iOS 5 IPSW get it here.

Steps:
1. Right click sn0wbreeze and set compatibility to windows XP (service pack 2) if you are on Windows 7 or Windows Vista and run as administrator.

2. Run it and click on “ok” then click “Close Credits” and after that click the blue arrow in the lower right-hand corner.

3. Make sure your firmware is somewhere you will have no trouble finding it, preferably your desktop. Browse for your iOS 5 firmware in Sn0wbreeze and select it.

4. Sn0wbreeze will automatically identify your iDevice after it is finished identifying the IPSW click the blue arrow in the lower right-hand corner.

5. For this Tethered beta jailbreak, you can just selected “simple mode” and click the blue arrow in the lower right-hand corner. If you selected “simple mode” skip steps 6 and 7. If you selected “expert mode” click the blue arrow in the lower right-hand corner and continue with the steps.

6.If you have an iPhone and need to Hactivate it, select the “Activate” option click the blue arrow in the lower right-hand corner.

7. Select build IPSW and click the blue arrow in the lower right-hand corner.

8. Put your iDevice into DFU mode by following these steps:

I. Hold down the power button for 3 seconds
II. Continue holding the power button and start holding the home button and continue HOLDING BOTH for 10 seconds
III. Let go of power and continue holding home button for 20 seconds (or until Sn0wbreese starts to run recognize your iDevice).

9. Open iTunes (if it’s not open already) and go to your iDevice in iTunes, then hold down Shift + left click restore. Browse for the IPSW that Sn0wbreeze created, it should be on your desktop by default.

10. Wait for it to finish.

11. After it is finish, run iBooty it should be on your desktop.

12. Select your iDevice.

16. Click “start” and follow the on screen instructions to put you device in DFU mode.

13. Wait for it too finish.

14. You are now jailbroken, may the jailbreak force be with you!

Troubleshooting:

If you get an error message TOWARDS THE END of your restore you will have to use TinyUmbrella to kick it out of recovery mode. Download TinyUmbrella here.

If you get iTunes 3194 error locate c:\windows\system32\drivers\etc\hosts delete any line with gs.apple.com or check out this post for assistance.

If you get iTunes 1600 error, download iReb(here) and use it to put you iDevice back into a pwn DFU state. Or check out this post for assistance.

:) Thank you for watching and don’t forget to subscribe :)

Both comments and pings are currently closed.

2 Responses to “How To Jailbreak OFFICIAL iOS 5 & Preserve Baseband iPhone 4/3Gs iPod Touch 4G/3G & iPad”

  1. Hydra says:

    hi can you help me? i do all the steps but when itunes fish it says that i dont disconnect the iphone that it will apear on itunes when the operation its compleat, but when apears it says that i need to restore it again :/ it dosnt exit of DFU mode, i downgraded to 4.1 to keep it functionall but how can i instal ios 5 without getting stuck in DFU mode?

    thx ;)

Thank you for watching and don’t forget to subscribe